I sanded the insides of the holes with my oscillating spindle sander and rounded the edges of the holes over with a 1/4 inch rounder bit in my router. Once the holes are drilled I cut along the outside lines of the rectangle with my jig saw and connected the two holes to make one large handle hole in each of the boards. Using a 2 inch forstner bit I drilled 2 holes in each board on the 2 center points I marked on the rectangle that were 1 inch in from the end. ( Credit: Etsy StonePointWoodwork) Fifteen of the blocks in this tower contains single holes for Jello shots and five of the blocks contain double holes, reads their Etsy page. These points will act as center marks for the holes that will be drilled I marked a center line horizontally across the rectangle and marked a point 1 inch in from each side. Remove and stack the blocks before someone topples the tower. Your turn ends 10 seconds after you stack the block or until the next player touches the block. Before you start a new story, a 3-block story needs to be completed. After drinking the shot blocks, place the block on the top of the tower. Tipsy Giant Jenga Game Has Random Blocks With Jello Shots Hidden Inside That You Take If You Pull.You’ve probably heard of dirty Jenga. From the center I measured 3 inches in each direction, marked 2 lines, measured down 4 inches from the top and marked a line across the board, measured 2 inches down from the top and marked another line across.įor the handles I first laid out a rectangle that was centered on each of the side boards 6 inches wide, 2 inches tall, and 2 inches down from the top of the board. Tipsy Topple comes with its own drinking rules. For the layout of the handles I first found the center point of both the left and right side boards.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |